7204hvi-sv не прошивается
Добавлено: 18 окт 2018, 21:26
нужна правильная прошивка на 7204hvi-sv.
U-Boot 2010.06 (Jul 26 2013 - 17:14:08)
*** Warning - bad CRC, using default environment
Hit ctrl+u to stop autoboot: 1 0
This program will upgrade software.
*******************************************************
* ATTENTION!! PLEASE READ THIS NOTICE CAREFULLY! *
* Don't reset machine,or anything that interrupt it. *
* The upgrade process must finish in 10 minutes! *
* If this program fails,machine might be unusable, *
* and you will need to reflash again. *
* If you find this too risky,power off machine now. *
*******************************************************
Now press [u/U] key to upgrade software: u
File system error,please upgrade by TFTP
Please input ip address of device: 192.1 0.0.64
Please input ip address of upgrade server: 192.0.012 .0 128
Confirm?(y/n): y
jffs2 part info : offset = 0x60000, size = 0xfa0000
MAC: 8C-E7-48-4D-D2-61
UP_PORT : phy status change : LINK=UP : DUPLEX=FULL : SPEED=100M
TFTP from server 192.0.0.128; our IP address is 192.0.0.64
Download Filename 'digicap.dav'.
Download to address: 0x80020000
Downloading: *# [ Connected ]
################################ [ 1.000 MB]
################################ [ 2.000 MB]
################################ [ 3.000 MB]
################################ [ 4.000 MB]
################################ [ 5.000 MB]
################################ [ 6.000 MB]
################################ [ 7.000 MB]
################################ [ 8.000 MB]
################################ [ 9.000 MB]
################################ [10.000 MB]
################################ [11.000 MB]
################################ [12.000 MB]
################################ [13.000 MB]
################################ [14.000 MB]
################################ [15.000 MB]
################################ [16.000 MB]
################################ [17.000 MB]
################################ [18.000 MB]
################################ [19.000 MB]
################################ [20.000 MB]
################################ [21.000 MB]
################################ [22.000 MB]
################################ [23.000 MB]
################################ [24.000 MB]
################################ [25.000 MB]
################################ [26.000 MB]
################################ [27.000 MB]
################################ [28.000 MB]
################################ [29.000 MB]
################################ [30.000 MB]
################################ [31.000 MB]
####
done
Bytes transferred = 32662946 (1f265a2 hex)
hicore.tar.lzma checkSum ok !
app.tar.lzma checkSum ok !
dvrCmd.tar.gz checkSum ok !
misc.tar.lzma checkSum ok !
hisi.tar.lzma checkSum ok !
uImage checkSum ok !
ramdisk.gz checkSum ok !
start.sh checkSum ok !
webs.tar.lzma checkSum ok !
logo.tar.lzma checkSum ok !
version checkSum ok !
player.bin checkSum ok !
new_10.bin checkSum ok !
new_20.bin checkSum ok !
jffs2: add update file(hicore.tar.lzma)...dirent name hicore.tar.lzma, len = 55
(3773520B->3840196B)done.
jffs2: add update file(app.tar.lzma)...dirent name app.tar.lzma, len = 52
(725800B->738704B)done.
jffs2: add update file(dvrCmd.tar.gz)...dirent name dvrCmd.tar.gz, len = 53
(11576B->11904B)done.
jffs2: add update file(misc.tar.lzma)...dirent name misc.tar.lzma, len = 53
(173056B->176172B)done.
jffs2: add update file(hisi.tar.lzma)...dirent name hisi.tar.lzma, len = 53
(979312B->996708B)done.
jffs2: add update file(uImage)...dirent name uImage, len = 46
(1917072B->1947496B)done.
jffs2: add update file(ramdisk.gz)...dirent name ramdisk.gz, len = 50
(909288B->925360B)done.
jffs2: add update file(start.sh)...dirent name start.sh, len = 48
(1648B->1648B)done.
jffs2: add update file(webs.tar.lzma)...dirent name webs.tar.lzma, len = 53
(2437736B->2480876B)done.
jffs2: add update file(logo.tar.lzma)...dirent name logo.tar.lzma, len = 53
(60976B->62120B)done.
jffs2: add update file(version)...dirent name version, len = 47
(16B->132B)done.
jffs2: add update file(player.bin)...dirent name player.bin, len = 50
(432640B->412056B)done.
jffs2: add update file(new_10.bin)...dirent name new_10.bin, len = 50
(1064B->628B)done.
jffs2: add update file(new_20.bin)...dirent name new_20.bin, len = 50
(1172B->696B)done.
Erasing SPI flash...done
Writing SPI flash...done
Upgrade check ......done
Upgrade success!
Press ENTER key to reboot
resetting ...
U-Boot 2010.06 (Jul 26 2013 - 17:14:08)
*** Warning - bad CRC, using default environment
Hit ctrl+u to stop autoboot: 1 0
MAC: 8C-E7-48-4D-D2-61
UP_PORT : phy status change : LINK=UP : DUPLEX=FULL : SPEED=100M
|RCV UDP pack timeout| TFTP server not found
16384 KiB hi_sfc at 0:0 is now current device
find_inode failed for name=devCfg.bin
load: Failed to find inode
### JFFS2 LOAD ERROR<0> for devCfg.bin!
file devCfg.bin doesn't exist
## Booting kernel from Legacy Image at 80400000 ...
Verifying Checksum ... OK
## Loading init Ramdisk from Legacy Image at 80800000 ...
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
U-Boot 2010.06 (Jul 26 2013 - 17:14:08)
*** Warning - bad CRC, using default environment
Hit ctrl+u to stop autoboot: 1 0
This program will upgrade software.
*******************************************************
* ATTENTION!! PLEASE READ THIS NOTICE CAREFULLY! *
* Don't reset machine,or anything that interrupt it. *
* The upgrade process must finish in 10 minutes! *
* If this program fails,machine might be unusable, *
* and you will need to reflash again. *
* If you find this too risky,power off machine now. *
*******************************************************
Now press [u/U] key to upgrade software: u
File system error,please upgrade by TFTP
Please input ip address of device: 192.1 0.0.64
Please input ip address of upgrade server: 192.0.012 .0 128
Confirm?(y/n): y
jffs2 part info : offset = 0x60000, size = 0xfa0000
MAC: 8C-E7-48-4D-D2-61
UP_PORT : phy status change : LINK=UP : DUPLEX=FULL : SPEED=100M
TFTP from server 192.0.0.128; our IP address is 192.0.0.64
Download Filename 'digicap.dav'.
Download to address: 0x80020000
Downloading: *# [ Connected ]
################################ [ 1.000 MB]
################################ [ 2.000 MB]
################################ [ 3.000 MB]
################################ [ 4.000 MB]
################################ [ 5.000 MB]
################################ [ 6.000 MB]
################################ [ 7.000 MB]
################################ [ 8.000 MB]
################################ [ 9.000 MB]
################################ [10.000 MB]
################################ [11.000 MB]
################################ [12.000 MB]
################################ [13.000 MB]
################################ [14.000 MB]
################################ [15.000 MB]
################################ [16.000 MB]
################################ [17.000 MB]
################################ [18.000 MB]
################################ [19.000 MB]
################################ [20.000 MB]
################################ [21.000 MB]
################################ [22.000 MB]
################################ [23.000 MB]
################################ [24.000 MB]
################################ [25.000 MB]
################################ [26.000 MB]
################################ [27.000 MB]
################################ [28.000 MB]
################################ [29.000 MB]
################################ [30.000 MB]
################################ [31.000 MB]
####
done
Bytes transferred = 32662946 (1f265a2 hex)
hicore.tar.lzma checkSum ok !
app.tar.lzma checkSum ok !
dvrCmd.tar.gz checkSum ok !
misc.tar.lzma checkSum ok !
hisi.tar.lzma checkSum ok !
uImage checkSum ok !
ramdisk.gz checkSum ok !
start.sh checkSum ok !
webs.tar.lzma checkSum ok !
logo.tar.lzma checkSum ok !
version checkSum ok !
player.bin checkSum ok !
new_10.bin checkSum ok !
new_20.bin checkSum ok !
jffs2: add update file(hicore.tar.lzma)...dirent name hicore.tar.lzma, len = 55
(3773520B->3840196B)done.
jffs2: add update file(app.tar.lzma)...dirent name app.tar.lzma, len = 52
(725800B->738704B)done.
jffs2: add update file(dvrCmd.tar.gz)...dirent name dvrCmd.tar.gz, len = 53
(11576B->11904B)done.
jffs2: add update file(misc.tar.lzma)...dirent name misc.tar.lzma, len = 53
(173056B->176172B)done.
jffs2: add update file(hisi.tar.lzma)...dirent name hisi.tar.lzma, len = 53
(979312B->996708B)done.
jffs2: add update file(uImage)...dirent name uImage, len = 46
(1917072B->1947496B)done.
jffs2: add update file(ramdisk.gz)...dirent name ramdisk.gz, len = 50
(909288B->925360B)done.
jffs2: add update file(start.sh)...dirent name start.sh, len = 48
(1648B->1648B)done.
jffs2: add update file(webs.tar.lzma)...dirent name webs.tar.lzma, len = 53
(2437736B->2480876B)done.
jffs2: add update file(logo.tar.lzma)...dirent name logo.tar.lzma, len = 53
(60976B->62120B)done.
jffs2: add update file(version)...dirent name version, len = 47
(16B->132B)done.
jffs2: add update file(player.bin)...dirent name player.bin, len = 50
(432640B->412056B)done.
jffs2: add update file(new_10.bin)...dirent name new_10.bin, len = 50
(1064B->628B)done.
jffs2: add update file(new_20.bin)...dirent name new_20.bin, len = 50
(1172B->696B)done.
Erasing SPI flash...done
Writing SPI flash...done
Upgrade check ......done
Upgrade success!
Press ENTER key to reboot
resetting ...
U-Boot 2010.06 (Jul 26 2013 - 17:14:08)
*** Warning - bad CRC, using default environment
Hit ctrl+u to stop autoboot: 1 0
MAC: 8C-E7-48-4D-D2-61
UP_PORT : phy status change : LINK=UP : DUPLEX=FULL : SPEED=100M
|RCV UDP pack timeout| TFTP server not found
16384 KiB hi_sfc at 0:0 is now current device
find_inode failed for name=devCfg.bin
load: Failed to find inode
### JFFS2 LOAD ERROR<0> for devCfg.bin!
file devCfg.bin doesn't exist
## Booting kernel from Legacy Image at 80400000 ...
Verifying Checksum ... OK
## Loading init Ramdisk from Legacy Image at 80800000 ...
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.